Monday, May 05, 2014

ETH008 - 8 relay outputs at 16A .

ETH008 - 8 relay outputs at 16A 


The ETH008 provides eight volt free contact relay outputs with a current rating of up to 16Amp each. The module is powered from a 12vdc supply which can be regulated or unregulated. The DC input jack is 2.1mm with positive core polarity, DC supplies are required to supply at least 500mA at 12vdc. The relays are SPCO (Single Pole Change Over) types. The normally open, normally closed and common pins are all available on the screw terminals. The ETH008 is fully compatible with the ETH-RLY16 and includes the legacy ETH-RLY16 command set.  

The ETH008 has additional features over the ETH-RLY16:
1. Full Factory Reset, all ETH008 firmware and settings can be reset to the original state. 
2. Firmware updates, firmware in the ETH008 is fully updateable by re-flashing the board with our custom windows program. This will be made available in the event of feature updates. 
3. New Command Format, the new command format allows for consistent compatibility with future boards. New commands now allow for pulsed control of relays from 100mS to 25.5 seconds. 
4. TCP/IP Password Protection, it is now possible to set a password for TCP/IP protection. This is independent of the configuration password. 



load type  Typical applications  Rating Max DC load capacity
 AC1 Non inductive or
 slightly inductive loads 
 16A @ 250V AC 
 AC15 Control of
 electromagnetic load
 (>72VA)
 3A @ 120V AC
 1.5A @ 240V AC 
 AC3 Control of motor  750W
 DC1 Non inductive or
 slightly inductive loads
 16A @ 24V DC 
 DC13 Control of electromagnetic
 loads
 0.22A @ 120V DC
 0.1A @ 250V DC