JX-dsPIC28
This board uses a 28-pin SDIP dsPIC30F device. The project board has a dsPIC30F2010 digital signal controller, power supply regulator, crystal oscillator, serial port interface, power-on indicator, reset pushbutton and a prototyping area.
Specifications:
Supports dsPIC 28-pin DIP version with On-Board dsPIC30F2010 Debugging and programming via LCD jack with ICDX-30 or ICD2 Programmable only by PX-800 programmer board Selection of RUN/PROG mode by switch Clock rate of 7.3728MHz Requires DC supply of 9-16V 500mA.
This board uses a 28-pin SDIP dsPIC30F device. The project board has a dsPIC30F2010 digital signal controller, power supply regulator, crystal oscillator, serial port interface, power-on indicator, reset pushbutton and a prototyping area.
Specifications:
Supports dsPIC 28-pin DIP version with On-Board dsPIC30F2010 Debugging and programming via LCD jack with ICDX-30 or ICD2 Programmable only by PX-800 programmer board Selection of RUN/PROG mode by switch Clock rate of 7.3728MHz Requires DC supply of 9-16V 500mA.
