MAXQ2000-RAX PROTOTYPE BOARD
FEATURES
- MCU: MAX2000-RAX up to 20 Mhz( single clock per instruction i.e. up to 20MIPS), low power 190 uA @ 8Mhz, power supply 1.8-2.5V, 16 bit microcontroller with 64 KB Flash (10K re-programming cycles), 2KB RAM, 3x 16bit Timers, 2x UART, 1x SPI, 1-wire, build-in driver for 132 segment LCD
- JTAG connector
- 20 Mhz (on socket) and 32 768 Hz oscillator crystal
- 2x RS232 connectors, one can be used for code bootloader
- 1x SPI port on connector
- 1-wire connector
- Buzzer
- Li-io 3V battery connector on board (no RS232 power supply when using this battery)
- Two buttons on ports with interrupts
- RESET button
- Status LED
- Power supply LED
- Two on-board power supply voltage regulators supplying +1.8-2.2-2.5V to core and +3.3V to GPIOs
- PWR_JTAG allow board to be power supplied by the JTAG (if MAXQ-JTAG-USB is used)
- Power supply filtering capacitors
- Extension headers for each uC pin on 0.1" row header
- PCB: FR-4, 1.5 mm (0,062"), green soldermask, white silkscreen component print
- Dimensions:100x80 mm (1.8x1.8")
- Prototype area with GND and 3.3V bus
- Power jack connector for AC/DC power supply
