OSM-10 Ollo Servo
- It is the motor used in OLLO; it is connected to CM-100, and the direction of spin and the speed of spin can be adjusted through port control.
- If it is set to "Spin Mode," it can be operated as the geared motor; if it is set to "Joint Mode," the motor can be moved to the designated location by setting the speed of spin(Power)and the value of location.
- It is mainly used to maintain certain angles pursuant to some conditions such as moving joints, moving steering devices, etc.
H/W Specification
- Weight : 16g
- Dimension : 18mm * 36mm * 27mm (with horn)
- Voltage : 3.0V
- Gear Ratio : 194:1
- Speed : 85 RPM(at 3.0V)
- Characteristics :
- Location Sensor (POT)
- Safety Device (Clutch) Installed
