Neo 1.2A DC motor controller module can control 1- 2 DC motor with two different spin directions. This module requires an additional controller that can control the motor. In addition, this module has been equipped with a Dual Full H-Bridge Driver, so this module can be directly connected to the motor.
Specifications:
- Based ATtiny2313 as a motorcycle driver's control center.
- Based TB6612FNG as a motor driver IC, so it requires no additional motor driver module.
- Able to control two motors individually / simultaneously with two different directions.
- Able to control a DC motor which has a voltage value of 2.5 VDC - 13.5 VDC and maximum continuous current consumption of 1.2 A.
- There are 4 levels to choose PWM frequency, 21.68 kHz, 2.71 kHz, 338.8 Hz, 84.7 Hz.
- Motor speed settings are available through the duty-cycle.
- Require an additional controller for SPC DC Motor 1.2A Neo can move the motor.
- Fully compatible with the microcontroller module DT-51 Series, AVR-DT or DT-Series Basic Series.
- Has two types of interfaces for communication with the controller / microcontroller, the TTL UART and I2C.
- Only use two channels of data to TTL UART interface (Tx and Rx) and I2C (SDA and SCL).
- Can be cascaded up to 8 modules when using the I2C interface.
- I2C address setting via software (I2C address setting can only be done through the UART-TTL interface).
- Has pin-out configuration of 16-pin DIP 600mil, so the module can be directly linked to the project board, PCB hole, or the IC socket 16-pin DIP 600mil.
- Dimensions: 5.8 cm x 3 cm x 1.7 cm
