Wednesday, July 21, 2010

RIC-E1, RIC-T1 E1, T1 Interface Converters

RIC-E1, RIC-T1 E1, T1 Interface Converters by RAD.

FEATURES

• Convert from V.35, X.21,V.36, RS-530 to E1 or T1 interfaces
• Connect 10BaseT and 100BaseT LANs and VLANs over E1 or T1 services
• Integrated IP router for connecting IP domains over E1/T1 services
• 10/100BaseT bridge supporting IEEE 802.3x flow control and back pressure
• Diagnostic loopback activation in compliance with ITU V.54 standard
• Plug and play

DESCRIPTION

• RIC-E1 and RIC-T1 interface converters enable communication between devices with E1/T1 interfaces and equipment with V.35, X.21, V.36, RS-530 interfaces.
• When equipped with IR-ETH/QN interface module, RIC-E1 and RIC-T1 transparently connect remote LANs and VLANs over unframed E1/T1 links utilizing the full E1/T1 bandwidth. The IR-ETH/QN interface modules support autonegotiation, allowing connection without additional configuration.
• RIC-E1 and RIC-T1 equipped with the IR-IP interface module operate as IP gateways, forwarding IP packets destined to the IP network. This prevents broadcast to the WAN and enables the LAN users to register for an IP multicast service.
• RIC-E1 and RIC-T1 feature front panel LEDs to indicate transmit/receive activity, E1/T1 signal loss condition and diagnostic loopback operation.
The rear panel LEDs of the Ethernet interface modules indicate the LAN status and activity.
• RIC-E1 and RIC-T1 are also available as plug-in cards for RADís ASM-MN-214, 19-inch card cage.

SPECIFICATIONS
E1/T1 INTERFACE
• Data Transmission Synchronous, full duplex
• Standard E1 or T1, unframed
• Line Code E1: HDB3 or AMI T1: B8ZS or AMI
• Line Impedance E1: 120Ω, balanced and 75Ω, unbalanced T1: 100Ω, balanced
• Range Up to 300m (1000 ft) over 24 AWG (0.5 mm) cable
• Connectors E1: RJ-45, 8-pin, balanced and two BNC coaxial, unbalancedT1: RJ-45, 8-pin, balanced


DTE INTERFACE
• Type V.35: via 34-pin, female X.21: via 15-pin, D-type, female RS-530: 25-pin, D-type, female V.36: 37-pin, D-type, female, via adapter cable IR-ETH (Ethernet bridge): RJ-45or BNC IR-ETH/QN (Ethernet/Fast Ethernet bridge): RJ-45IR-IP (IP router): RJ-45