Neo 2.4A Stepper Motor controller module is a round fruit with a stepper motor full step or half step. This module requires an additional controller that can control the motor. In addition, this module has been equipped with a Dual Full H-Bridge Driver, so this module can be directly linked to bipolar and unipolar stepper motors.
Specifications:
- Based ATtiny2313 as a motorcycle driver's control center.
- Based on the A3995 motor driver IC, so it requires no additional motor driver module.
- Able to control a DC motor which has a voltage value 8VDC - 36VDC and a maximum continuous current consumption of 2.4 A.
- Capable of controlling the motor in half step or full step.
- Require an additional controller to move the motor.
- Fully compatible with the microcontroller module DT-51 Series, AVR-DT or DT-Series Basic Series.
- Has two types of interfaces for communication with the controller / microcontroller, the TTL UART and I2C.
- The movement of a stepper motor: Continuous Run, Pulse Count Run, Brake and Stop.
- Neo SPC working on Stepper Motor 2.4A 4.8 VDC power supply level - 5.4 VDC.
- Pin input / output compatible with TTL and CMOS voltage levels.
- Only use two channels of data to TTL UART interface (Tx and Rx) and I2C (SDA and SCL).
- Can be cascaded up to 8 modules when using the I2C interface.
- I2C address setting via software (I2C address setting can only be done through the UART-TTL interface).
- Has pin-out configuration of 16-pin DIP 600mil, so the module can be directly linked to the project board, PCB hole, or the IC socket 16-pin DIP 600mil.
- Dimensions: 5.9 cm x 3.1 cm x 1.7 cm