Introducing the all new HS-5055MG Metal Gear Feather Servo. Tired of having your sub-micro servos strip gears? The HS-5055Mg is the solution! Not only does this servo have super-strong metal gears but it also incorporates the latest in digital technology. Along with a Hitec programmer, you can change a number of performance characteristics of the HS-5055MG. We offer the new HS-5055MG servo in several configurations, 90° stock rotation, 120° modified rotation (programmed), and reverse rotation.
Programable Features:
- Dead Band Width
- Direction of Rotation
- Speed of Rotation (slower)
- End Points (up to 120 degrees)
- Neutral Points
- Fail Safe On/Off
- Fail Safe Points
- Resolution (default is set at high)
- Overload Protection (default is off)
Detailed Specifications
- Control System: +Pulse Width Control 1500usec Neutral
- Required Pulse: 4.8-6.0 Volt Peak to Peak Square Wave
- Operating Voltage Range: 4.8-6.0 Volts
- Operating Temperature Range: -20° to +60° C (-4°F to +140°F)
- Operating Speed (4.8V): 0.20 sec/60° at no load
- Operating Speed (6.0V): 0.17 sec/60° at no load
- Stall Torque (4.8V): 18.05 oz/in. (1.3kg.cm)
- Stall Torque (6.0V): 22.2 oz/in. (1.6kg.cm)
- Operating Angle: 45 Deg. one side pulse traveling 400usec
- 360 Modifiable: No
- Direction: Clockwise/Pulse Traveling 1500 to 1900usec
- Idle Current Drain (4.8V): 3mA at stop
- Idle Current Drain (6.0V): 3mA at stop
- Dead Band Width: 2usec
- Motor Type: Carbon Brush
- Potentiometer Drive: 6 Slider Indirect Drive
- Bearing Type: Plastic
- Gear Type: Metal Gears
- Connector Wire Length: 7" (178mm)
- Dimensions: .89" x 0451"x .94" (22.8 x 11.6 x 24mm)
- Weight: .33oz (9.5g)